The LoRaWAN Fragmented Data Block Transport service (subsys/lorawan/services/frag_transport.c) does not validate the fragment counter in a received DATA_FRAGMENT command before forwarding it to the configured decoder. In frag_transport_package_callback() the value frag_counter = hdr->frag_index_n & 0x3FFF is taken directly from the downlink payload and passed to the decoder, which derives an array index and flash offset as frag_counter - 1. DataFragment fragments are 1-indexed, so a frag_counter of 0 underflows that arithmetic. With the default Semtech/LoRaMAC-node decoder, this reaches FragDecoder.FragNbMissingIndex[fragCounter - 1] = 0; in FragDecoderProcess(), where fragCounter - 1 evaluates to -1 and writes a uint16_t zero out of bounds, just before the array and into the adjacent MatrixM2B recovery-matrix state of the static decoder object (CWE-787). A companion write derives a wild flash offset, but that path is rejected by the flash_area_write() bounds check. The in-tree low-memory decoder (frag_dec()) is not corrupted: its out-of-range bit-array and flash accesses are caught by sys_bitarray_ and flash_area_ bounds checks. The handler is the registered downlink callback for the fragmentation transport port, reachable whenever an active fragmentation session exists, so the triggering byte is attacker-influenceable LoRaWAN/FUOTA network input. Triggering it requires authenticated downlinks (LoRaWAN MAC session keys or a malicious/compromised network or FUOTA server) and an active fragmentation session. The impact is contained: corruption of decoder state and denial of the firmware-update (FUOTA) session rather than controllable memory corruption or code execution. The fix adds a transport-layer check that rejects frag_counter == 0, closing the defect for both decoder backends.